Our 2-bay storage RAID enclosure product now supports the S.M.A.R.T (Self Monitoring, Analysis, and the Reporting Technology) feature.You just have to open this RAIDGuide Manager utility, you then can enjoy using it to know the HDD quality status, and you could even to replace any HDD which is with critical quality level in advance to help an even better protection for all your data.

 

Below charts are to give you a good picture to use this new S.M.A.R.T feature:

 

Under RAID 0 mode, it monitors each HDD

 

 

 

Under RAID 0 mode, it alerts "Warning" while detecting HDD with a critical condiction ,we would recommend to replace the hard drive.   

 

 

 

Under RAID 1 mode, it alerts "Error" while detecting HDD with a serious damage , we strongly request to replace the defective hard disk. 

 

 

Worst:  The worst HDD quality level

Value:  The current HDD quality level

Threshold:The critical HDD quality level HDD becomes defect when detecting data is higher than Threshold.

 

Remark:The new GUI Utility (with S.M.A.R.T) is only available for limit product.Please contact to Raidon Customer Service Department (CSD) for the product detailed to:

 

• CSD E-mail Address:        supporting@raidon.com.tw
• CSD Phone Line:              +886-2-2278-9697, extension# 21

 

 

The product list which support the new GUI Utility:(update 20220504)

 

Product	GUI version after v0.50.11-2	Remark
iR2771	Yes	After ver 160729_1 firmware
iR2772	Yes	After ver 160729_1 firmware
SR2611-2S-S2R+	Yes	After ver 160729_1 firmware
iR2622	Yes	After ver 160729_1 firmware
iR2623	Yes	After ver 160729_1 firmware
GR3680-SB3	Yes	After ver 160729_1 firmware
iR2031	Yes	After ver 160729_1 firmware
iR2624	Yes	After ver 160729_1 firmware
iR2023	Yes	After ver 160729_1 firmware
iR2622	Yes	After ver 160729_1 firmware
GR3680 series	Yes	After ver 160729_1 firmware

2016-07-25